Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller

PC5 Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller PC5 1024x682

Pin it on Pinterest Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller pinterest
Share on Facebook Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller facebookShare on LinkedIn Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller linkedinShare on Tumblr Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller tumblr
 Share Raptor 700 ’09-’14 Dynojet Power Commander V FI Controller social share icon small
  • Features fuel and timing control, Rev Xtend and is a reduced size from the PCIII USB
  • Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
  • The Power Commander III USB allowed you to add extra fuel during start-up based on number of revolutions of the engine – Now the easy-to-install Power Commander V reads the exact engine temp through the bikes own ECM, allowing the tuner to choose how much fuel to add
  • More tuning ranges than PCIII USB
  • Enhanced accel pump utility
  • USB powered from computer; 9 volt adapter is no longer needed
  • Cold starting on heavily modified engines should now be much more controllable and easy to adjust
  • Software displays J1850 data from bikes stock ECU
  • Two-position map switching function built in
  • Can add any SPST switch and toggle between two different fuel/timing maps
  • Gear/speed input allows for map adjustment based on gear
  • Analog input allows user to install any 0-5 volt sensor
  • Build an adjustment table based on analog input such as boost or temperature
  • Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
  • Ten throttle position columns
  • Made in the U.S.A.

Could not load product information